Jump to contentJump to page navigation: previous page [access key p]/next page [access key n]
Applies to SUSE Linux Enterprise Server 15 SP1

1 RMT Installation and Configuration Edit source

RMT is included in SUSE Linux Enterprise Server starting with version 15. Install RMT directly during the installation of SUSE Linux Enterprise Server or install it on a running system. After the packages are installed, use YaST to do an initial configuration.

1.1 Installation During System Installation Edit source

To install it during installation, select the rmt-server package. The package selection is available in the Installation Settings step of the installation when selecting Software.

RMT Pattern
Figure 1.1: RMT Pattern

We recommend to check for available RMT updates immediately after installing SUSE Linux Enterprise Server using the zypper patch command. SUSE continuously releases maintenance updates for RMT, and newer packages are likely to be available.

1.2 Installation on Existing System Edit source

To install RMT on a running SUSE Linux Enterprise Server installation, use zypper:

tux > sudo zypper in rmt-server

1.3 RMT Configuration with YaST Edit source

Configure RMT with YaST as described in the following procedure. It is assumed that this procedure is executed on a newly installed system.

  1. Start YaST with the rmt module.

    tux > sudo yast2 rmt

    Alternatively, start YaST and select Network Services › RMT Configuration.

  2. Enter your organization credentials. To retrieve your credentials, refer to Section 3.1, “Mirroring Credentials”.

  3. Enter credentials for a new MariaDB user and database name. This user will then be created. Then select Next.

    If a password for the MariaDB root user is already set, you are required to enter it. If no password is set for root, you are asked to enter a new one.

  4. Enter a common name for the SSL certificates. The common name should usually be the fully qualified domain name (FQDN) of the server. Enter all domain names and IP addresses with which you want to reach the RMT server as alternative common names.

    When all common names are entered, select Next.

  5. To view a final summary, select Next. Then select Finish to close YaST. YaST then enables and starts all systemd services and timers.

  6. If you have a firewall enabled, allow access to ports 80 and 443. When using the default zone public, execute the following commands:

    tux > sudo firewall-cmd --zone=public --add-port=80/tcp --permanent
    tux > sudo firewall-cmd --zone=public --add-port=443/tcp --permanent
    tux > sudo firewall-cmd --reload
Print this page