Jump to contentJump to page navigation: previous page [access key p]/next page [access key n]
documentation.suse.com / SUSE Linux Enterprise High Availability Extension – Dokumentation / Geo Clustering Guide / Requirements
Applies to SUSE Linux Enterprise High Availability 15 SP3

3 Requirements

Software requirements
  • All machines (cluster nodes and arbitrators) that will be part of the cluster need at least the following modules and extensions:

    • Basesystem Module 15 SP3

    • Server Applications Module 15 SP3

    • SUSE Linux Enterprise High Availability 15 SP3

  • When installing the machines, select HA GEO Node as system role. This leads to the installation of a minimal system where the packages from the pattern Geo Clustering for High Availability (ha_geo) are installed by default.

Network requirements
  • The virtual IPs to be used for each cluster site must be accessible across the Geo cluster.

  • The sites must be reachable on one UDP and TCP port per booth instance. That means any firewalls or IPsec tunnels in between must be configured accordingly.

  • Other setup decisions may require to open more ports (for example, for DRBD or database replication).

Other Requirements and Recommendations
  • All cluster nodes on all sites should synchronize to an NTP server outside the cluster. For more information, see the Administration Guide for SUSE Linux Enterprise Server 15 SP3.

    If nodes are not synchronized, log files and cluster reports are very hard to analyze.

  • Use an uneven number of sites in your Geo cluster. In case the network connection breaks down, this makes sure that there still is a majority of sites (to avoid a split brain scenario). In case you have an even number of cluster sites, use an arbitrator for handling automatic failover of tickets. If you do not use an arbitrator, you need to handle ticket failover manually.

  • The cluster on each site has a meaningful name, for example: amsterdam and berlin.

    The cluster names for each site are defined in the respective /etc/corosync/corosync.conf files:

    totem {
        [...]
        cluster_name: amsterdam
        }

    Change the name with following crmsh command:

    # crm cluster rename NEW_NAME

    Stop and start the cluster services for the changes to take effect:

    # crm cluster restart
  • Mixed architectures within one cluster are not supported. However, for Geo clusters, each member of the Geo cluster can have a different architecture—be it a cluster site or an arbitrator. For example, you can run a Geo cluster with three members (two cluster sites and an arbitrator), where one cluster site runs on IBM Z, the other cluster site runs on x86, and the arbitrator runs on POWER.